Woodwind.OrgThe Oboe BBoardThe C4 standard

 
  BBoard              
 
 New Topic  |  Go to Top  |  Go to Topic  |  Search  |  Help/Rules  |  Smileys/Notes  |  Log In   Previous Message  |  Next Message 
 Re: differences in adjustment of mechanism between the oboe and english horn
Author: Chris P 
Date:   2012-07-19 12:17

Most of the mechanism and adjustments on cors are as you'd find on oboe, the cor also has an A vent on the top joint which is closed by LH3 so be sure both the LH3 and A vent pads close together.

Depending on the make, the split top plate (for LH1) will either have only one screw to adjust the height of the upper plate which controls the venting of both plates, or two screws so both plates can be adjusted. If you lift LH1 off (instead of rolling down), then you'll probably need to have the lower plate set so it almost closes. This can be done on cors without the adjusting screw fitted by fitting a thick cork wedge to the bridge to make contact with the joint surface to close the top plate down almost closed (if the angle of the bridge allows it) or by having an adjusting screw fitted to the key barrel the lower plate runs on which is right by the end pillar of the LH main action. An adjusting screw is infinitely better as it allows for fine adjustment.

The trickiest area of adjustment on cors is the right hand main action as there's a lot more going on here compared to oboes, as well as the arrangement of the F vent which (on most cors) only closes when both RH 2 and 3 are closed together - it has to remain open for E which is the worst note on cors (especially low E) and needs all the help it can get.

The adjusting screw on the low C touchpice arm on a lot of cors will also close off the F vent and the one to lower the RH2 fingerplate is in between the RH Eb touch and the low C key pad cup. Some (eg. Howarth XL) have both the adjusting screws positioned right next to each other on the low C touch arm, the upper one (nearest to the RH3 fingerplate) is to adjust the closure of the RH2 fingerplate and the one going through the touchpiece arm closes the F vent.

Former oboe finisher
Howarth of London
1998 - 2010

The opinions I express are my own.

Post Edited (2012-07-19 22:24)

 Reply To Message  |  Avail. Forums  |  Flat View   Newer Topic  |  Older Topic 

 Topics Author  Date
 differences in adjustment of mechanism between the oboe and english horn  new
HautboisJJ 2012-07-19 08:04 
 Re: differences in adjustment of mechanism between the oboe and english horn  new
Chris P 2012-07-19 12:17 
 Re: differences in adjustment of mechanism between the oboe and english horn  new
huboboe 2012-07-19 19:35 


 Avail. Forums  |  Need a Login? Register Here 
 User Login
 User Name:
 Password:
 Remember my login:
   
 Forgot Your Password?
Enter your email address or user name below and a new password will be sent to the email address associated with your profile.
Search Woodwind.Org

Sheet Music Plus Featured Sale

The Clarinet Pages
For Sale
Put your ads for items you'd like to sell here. Free! Please, no more than two at a time - ads removed after two weeks.

 
     Copyright © Woodwind.Org, Inc. All Rights Reserved    Privacy Policy    Contact charette@woodwind.org