 The Clarinet BBoard
|
Author: claire Inet
Date: 2013-11-27 11:34
I just received my 'new' used Vito bass. I need to cut the floor peg down a bit, as only one end is small enough to go into the clamp and the other end is too long.
Anyway, I wanted to be sure that I could get another peg before I cut this one. Of course, they're available for $20-30. My measurements show that the rod is close to 17/64" or 7 mm. 17/64 is not a size that you're going to find easily and certainly not at your local big box store.
7 mm rod is available here http://www.orangealuminum.com/round-rods/round-rods-270.html for a few bucks. It's a 6 foot length, so you'd have enough for the whole section.
|
|
Reply To Message
|
|
Author: David Spiegelthal ★2017
Date: 2013-11-27 14:53
Ferree's Tools can sell you the peg alone or an entire assembly. They have these for both Leblanc and Selmer-USA/Bundy designs.
|
|
Reply To Message
|
|
Author: BobD
Date: 2013-11-27 18:28
You can use 1/4 inch rod from any hardware store........
Bob Draznik
|
|
Reply To Message
|
|
Author: 2E
Date: 2013-11-28 08:50
Stephen Fox has them available for sale on his website.
Hope that helps!
2E
Post Edited (2013-11-28 08:54)
|
|
Reply To Message
|
|
The Clarinet Pages
|
 |
.jpg){kind=small}
.jpg){kind=small}
.jpg){kind=small}
.jpg){kind=small}
.jpg){kind=small}
.jpg){kind=small}
