The Oboe BBoard
|
Author: DeletedUser
Date: 2018-05-10 08:14
Can someone give me an answer on the cork gasket that fits between the combination d/e key - I would like to know if it is GLUED in place or does it just sit there and float.
|
|
Reply To Message
|
|
Author: jhoyla
Date: 2018-05-10 11:14
If you are talking about the split E key (RH, 4th finger), it certainly should not float. It is generally glued to the bottom half of the split key.
Make sure you don't glue the two keys together if you are repairing.
|
|
Reply To Message
|
|
Author: DeletedUser
Date: 2018-05-11 04:20
Thank you that is what I thought because it doesn't stay in place anyway.
But I have another question should the gasket fit right over the bottom half of the hole on the key or should I replace it with the same on that I tool off which was just a thin cork that just makes the seal.
|
|
Reply To Message
|
|
Author: Chris P
Date: 2018-05-11 15:35
The RH3 split D#-E trill key needs the ring of cork to keep the ring key at a specific height and isn't acting as a seal, so it doesn't really need to make full contact all the way around as a pad does against its tonehole.
Find the ideal thickness of cork so the ring key sits evenly around the inner bush (slightly higher than the bush, but evenly all round like a ring key should), then cut the appropriate diameter disc of that thickness cork (usually around 12.5mm) and punch out the centre (around 8mm) so it slips over the bush.
The best way to stick that on is apply contact adhesive to just the top side of the bush (once cleaned and degreased) and fit the cork disc while the adhesive is still fresh, using the outer ring to push it down.
That's probably the only time you'd use contact adhesive in this manner as opposed to using it in the proper way (applying to both surfaces and waiting for it to become touch dry before sticking both surfaces together).
It's not going to fall off as the central bush will keep it in place. The adhesive will go off in time, so it's not going to come adrift.
If the ring key is sitting at a funny angle in relation to the bush, then check the pad is sitting evenly in the pad cup (and reseat or change it if it isn't), then adjust the ring key so it also sits evenly when the ideal thickness of cork is placed between the ring key and the bush.
Ring keys on all woodwinds should always be even all the way around in relation to the tonehole chimney or bush they surround - the height of the ring key depends on the players hand and finger size and should be set up accordingly.
Former oboe finisher
Howarth of London
1998 - 2010
The opinions I express are my own.
Post Edited (2018-05-11 15:38)
|
|
Reply To Message
|
|
The Clarinet Pages
|
|