The Clarinet BBoard
|
Author: Steven
Date: 2004-06-22 17:23
Anyone know about a Conn 44N Bb Albert system clarinet? I have one, its either ebonite or hard rubber, in need of an overhaul but it seems to require odd size pads. Apparently it needs shoulderless pads (at least on the lower joint) because the cutout arount the tone holes won't accomodate a pad that sticks out over the edge of the cup. Also, key heights are set so it would seem to require relatively thin pads. I picked this up cheap as a DIY experiment, but it was actually a surprisingly good sounding horn, and I'd like to complete the project with properly fitted pads.
|
|
|
TooManyHorms |
2003-12-04 19:59 |
|
paulwl |
2003-12-05 04:07 |
|
TooManyHorms |
2003-12-05 13:43 |
|
Ralph Katz |
2003-12-05 14:54 |
|
paulwl |
2003-12-05 18:05 |
|
Vytas |
2003-12-06 22:40 |
|
DezzaG |
2004-06-22 09:49 |
|
TooManyHorms |
2003-12-06 03:53 |
|
paulwl |
2003-12-06 14:33 |
|
paulwl |
2003-12-07 00:19 |
|
Vytas |
2003-12-07 18:44 |
|
Vytas |
2003-12-07 18:52 |
|
paulwl |
2004-01-19 21:43 |
|
TooManyHorms |
2004-01-20 13:11 |
|
Ralph Katz |
2003-12-07 12:30 |
|
paulwl |
2003-12-07 14:27 |
|
paulwl |
2003-12-08 01:34 |
|
Ralph Katz |
2003-12-08 14:07 |
|
paulwl |
2003-12-08 15:58 |
|
paulwl |
2004-01-20 14:50 |
|
jmsa |
2004-06-22 13:31 |
|
Steven |
2004-06-22 17:23 |
|
jbutler |
2004-06-23 16:10 |
|
Don Berger |
2004-06-23 16:25 |
|
Vytas |
2004-06-23 16:51 |
|
Travis |
2008-01-31 21:12 |
|
The Clarinet Pages
|
|