The Clarinet BBoard
|
Author: Clari
Date: 2003-08-21 23:02
Is there any easy way to remove ligature scratch and renew the faded rubber?
thx
Clari
|
|
Reply To Message
|
|
Author: icecoke12
Date: 2003-08-22 06:24
The question was whether there is any easy way to remove the ligature scratch mark...... Since when anyone asked whether removing the marks will improve the tone.
I would be interested to know how too...
|
|
Reply To Message
|
|
Author: Don Berger
Date: 2003-08-22 14:33
Prob. not, if not "fillable", a deep scratch-gouge 's removal would prob. require removal of quite a bit of "lower-back" of the mp, so would require a smaller dia. ligature. Like with a mp chip, if its "psychologically [sp?] unattractive", good luck in mp-hunting. Don
Thanx, Mark, Don
|
|
Reply To Message
|
|
Author: beejay
Date: 2003-08-22 17:04
I successfully restored a mouthpiece that had been chewed up by a dog (don't ask!) by using Milliput as a filler, coloring with an indelible black marker and polishing with Klinomint toothpaste. I can't see the repair.
|
|
Reply To Message
|
|
Author: ron b
Date: 2003-08-22 17:10
Hi, Clari
I've had pretty good success with Ferree's "Jet Magic". Use it for a filler, as you would use epoxy; in fact, black epoxy works as well (for me) in most cases. The advantage of black epoxy is that you can buy it every day at most local hardware/home improvement stores.
Clean the area to be repaired. You don't want any grease or other contaminants to spoil you effort. Follow mixing instructions for whichever product you choose to apply, fill the area, let it set overnight, then dress it down to the same surface level as the surrounding piece. I use fine, very fine, then finest grit wet-or-dry abrasive paper I can find, followed by crocus cloth. I like to contact cement the paper or cloth to shortened pieces of wooden paint stir sticks, or tongue depressors, to stiffen it. Polish to approximately the same luster as the rest of the (mouth)piece, or as close as you can get, and you'll hardly notice that there was a scratch or gouge.
My old standby favorite for "faded mouthpiece symdrome" is 50-50 bleach/water. Let stand until the discoloration has vanished, anywhere from half an hour to up to two or three hours. Rinse thoroughly and polish lightly. Avoid rubbing rails and tip.
Happy Tootin' !!!
- rn b -
|
|
Reply To Message
|
|
Author: Jack Kissinger
Date: 2003-08-22 18:39
In the Klarinet archives, you should be able to find a posting by Tony Pay suggesting that hard rubber has a "memory" and sometimes nicks, etc. can be removed by the *careful* application of heat. I tried his suggestion once on a mouthpiece that had a small nick in the tip and it actually worked to some extent. Ligature marks are only cosmetic, however, so I probably wouldn't risk it on a good-playing mouthpiece.
Best regards,
jnk
|
|
Reply To Message
|
|
Author: sfalexi
Date: 2003-08-22 20:35
I'd leave it. Unless it's in danger of going all the way through the mouthpiece or really affecting the tone, I'd leave it. I'd consider to be a battle scar and, IMHO, marks like this add character to a clarinet. Sort of a "I'm old but I'm still going strong" type of thing.
Alexi
US Army Japan Band
|
|
Reply To Message
|
|
The Clarinet Pages
|
|