Author: kdk ★2017
Date: 2019-01-13 12:51
GenEric wrote:
> Are there
> any resources with dimensions on standard barrels (possibly
> Moennig?) or mouthpieces?
The best resource would be a barrel that you like. Measure the taper at each end and at a few points inside the bore.
For a mouthpiece, again, facing specs could be measured from a model. I don't know if the CNC can cut the inside bore, chamber and baffle, but those, too can be measured in an existing model, though, to get at the fine details, you might have to cut the mouthpiece in half.
I doubt if most of these dimensions are available - I think they're generally proprietary to the individual manufacturer.
Barrels would be easier as a first project. There are fewer interrelated parameters involved.
Karl
|
|