The Clarinet BBoard
|
Author: clarnibass
Date: 2017-04-02 08:14
If improving the slot will not dig too deep into the screw (weakening the slot "walls"), then you can just do that and reuse them (if they are fine otherwise).
Although the chance that that another model has the exact same screw is low, it's often likely that some model has pretty similar screw, enough that it's much easier to modify one than to make a new one. Unless someone happens to know, or you can take enough measurements to be able to check, it's usually a matter of trying different ones until one works for this.
|
|
|
StevenWayne |
2017-03-30 17:25 |
|
Bob Bernardo |
2017-03-30 18:25 |
|
Caroline Smale |
2017-03-30 20:48 |
|
Wes |
2017-03-31 00:02 |
|
StevenWayne |
2017-04-02 04:21 |
|
Tony F |
2017-04-02 06:58 |
|
Re: Source for pivot screws? new |
|
clarnibass |
2017-04-02 08:14 |
|
The Clarinet Pages
|
|