Klarinet Archive - Posting 000131.txt from 2011/06

From: "Karl Krelove" <kkrelove@-----.net>
Subj: Re: [kl] Keeping screws in place
Date: Wed, 15 Jun 2011 15:00:50 -0400

I was taught early on by Hans Moennig that if the screws fit correctly, they
won't bind the mechanism even when fully tightened.

Karl

> -----Original Message-----
> From: Rachel Roessel [mailto:gsurosey@-----.com]
> Sent: Wednesday, June 15, 2011 2:33 PM
> To: The Klarinet Mailing List
> Subject: Re: [kl] Keeping screws in place
>
> Forgive me if this is a dumb question, but won't screwing the screw
> really tight
> restrict movement of the mechanism? Or is it built to work around that?
> I make
> sure my screws are snug, but I don't tighten them to the point where I
> don't
> think I can get them out again (at least on the pivot screws - the rods
> seem to
> take care of themselves).
>
> Rachel
>

_______________________________________________
Klarinet mailing list
Klarinet@-----.com
To do darn near anything to your subscription, go to:
http://klarinet-list.serve-music.com