Klarinet Archive - Posting 000080.txt from 2011/02

From: George Kidder <gkidder@-----.org>
Subj: Re: [kl] Removing barrel rings
Date: Fri, 11 Feb 2011 08:15:47 -0500

What is the proper debonding solution for the glue used? Many solutions
(eg acetone) would seem to be bad news for a plastic barrel?

But maybe not.

George

At 02:04 PM 2/9/2011, you wrote:
>If it was made in Asia the rings were probably glued so a debonding solution
>would work.
>
>________________________________
>From: George Kidder <gkidder@-----.org>
>To: The Klarinet Mailing List <klarinet@-----.com>
>Sent: Wed, February 9, 2011 1:34:02 PM
>Subject: [kl] Removing barrel rings
>
> >
>Over the years, there has been a lot of discussion about tightening barrel
>and bell rings - but I have seen nothing about getting them off. I have in
>mind cutting down
>one for playing at higher pitch - I have the tools for it - but will need
>to remove one ring to do the work. (I am starting out with an old plastic
>barrel, of course!)
>
>Any thoughts on how to get the ring(s) off?
>
>George
>
>
>
>_______________________________________________
>Klarinet mailing list
>Klarinet@-----.com
>To do darn near anything to your subscription, go to:
>http://klarinet-list.serve-music.com
>
>
>_______________________________________________
>Klarinet mailing list
>Klarinet@-----.com
>To do darn near anything to your subscription, go to:
>http://klarinet-list.serve-music.com
>
>_______________________________________________
>Klarinet mailing list
>Klarinet@-----.com
>To do darn near anything to your subscription, go to:
>http://klarinet-list.serve-music.com

_______________________________________________
Klarinet mailing list
Klarinet@-----.com
To do darn near anything to your subscription, go to:
http://klarinet-list.serve-music.com

   
     Copyright © Woodwind.Org, Inc. All Rights Reserved    Privacy Policy    Contact charette@woodwind.org