Klarinet Archive - Posting 000526.txt from 1997/10

From: Jrykorten@-----.com
Subj: Re: Manufacturing Tolerances
Date: Mon, 13 Oct 1997 10:10:11 -0400

In a message dated 97-10-10 21:31:05 EDT, Dee writes:

<<
Neither one of us designs clarinets or clarinet manufacturing processes so
neither one of us is really in a position to judge if 0.004" is acceptable
or
not. So to make a statement that it is acceptable (yes I know I said it was
good
but I should not have) or unacceptable (as a couple of others have stated
and
should not have) is not warranted. Now if someone on this list happens to
be in
the field of manufacturing clarinets, perhaps they can fill us in a little
bit
and then we would be in a better position to make such a judgement.

Dee Hays
deerich@-----.net
Canton, SD
>>

Good point! Now do you really think Clarinet manufacturers would read such an
rich source of consumer input as Klarinet? That would make too much sense!

Jerry Korten

   
     Copyright © Woodwind.Org, Inc. All Rights Reserved    Privacy Policy    Contact charette@woodwind.org